Faulty home button of your iPhone can cause you a lot of trouble. if the home button is unresponsive or not working properly then you must go for fixing your iPhone home button. As Techyuga is Kolkata’s best iPhone repair & service center we have this DIY guide for you  today. Read this  iPhone 5C Home Button Repair Guide –

 

 

If you are facing any kind of issue with your iPhone or apple device then we can help you with that, We are the best place for iPhone Repair in Kolkata. Techyuga has brought city’s best technical experts to your door, Just call us at 9088888835 or Live chat with our support representatives. Or you can directly book a technician here.

 

 iPhone 5C Home Button Repair 

 

Power off your iPhone

 

switching off iPhone 5C

 

Before performing any repair on any iPhone, iPad, or iPod touch you should always remember to power it off. Simply hold down on the Power button until you see Slide to Power off. One you’re sure your iPhone is turned off, proceed to the next section.

 

Remove the two security screws on both sides of the dock connector

 

Removing security screws in iPhone 5C

 

There are two security screws that secure the screen to the frame and they sit on each side of the dock connector. Use your 5-point security screwdriver to remove them. They are both the same size so it’s okay if you mix them up.

 

Remove the display assembly

 

Place your suction cup slightly above the Home button assembly and secure it to the screen.

 

removing iPhone 5C display by suction cup method

 

Holding the iPhone in place with one hand, gently pull upwards on the suction cup until you free the bottom of the screen. You should now be able to use your fingers to slowly raise up the screen and expose where the front assembly is connected to the logic board.

 

Removing screws in iPhone 5S

 

Remove the four screws holding down the shield that covers the display cables. To do this, use your #000 screwdriver. These screws are different sizes so make sure you keep them organized in a way you can remember for re-assembly.

 

Removing screws in iPhone 5C

 

Once all four screws are removed, carefully remove the shield and set it aside.

Now use your spudger tool in order to remove the three cables shown in the image below.

 

Removing cables in iPhone 5C

 

The display assembly should now be free from the body of the phone. Go ahead and set everything but the display assembly aside now.

Need help about iPhone 5S Home Button Repair ? get help from Kolkata’s Best iPhone Repair Center.

 

Replace the Home button assembly

 

Remove the two screws shown below using your #000 Phillips screwdriver.

 

Removing screws around home button iPhone 5C

 

Use your iSesamo opening tool or a flat end of a razor blade to peel off the cable attached to the shield.

 

Removing shield home button iPhone 5C

 

Peel the cable off the shield and replace it with the new one making sure the alignment is correct.

Screw down the Home button shield and stick the new cable down to the front of the assembly like you found the old one.

Test the Home button by pressing it to ensure that it depresses correctly and feels okay.

 

5. Re-connect the display assembly

 

Carefully reconnect the three cables running from the display assembly to the logic board.

 

Removing cables in iPhone 5C

 

Reposition the metal shield that sits over the three cables and replace the four screws that hold it in place, remembering where each one came from — they are all different sizes.

Line up the top of the screen carefully and make note of the teeth that line up to the top of your iPhone 5c’s frame. Once the top of the display is lined up, carefully snap down the remainder by moving your fingers along the edge.

 

6. Replace the security screws on each side of the dock connector

 

Removing security screws in iPhone 5C

 

Once you are confident that the display is seated correctly again, use your security screwdriver in order to replace the two screws on either side of the dock connector.

 

7. Test the new Home button cable

 

In order to test the Home button cable, do the following:

Single press while inside of apps to make sure you get returned to the Home screen
Long press to make sure Siri launches

Double and triple click to make sure these functions work as well

Press and hold the Home and Power buttons to ensure your iPhone reboots as it should.

 

 

Call 9088888835 OR Live chat with our engineers here, You can also book a technician below. For more information, visit our iphone repair in kolkata page HERE

 

TRENDING POSTS