was successfully added to your cart.

iPhone 7 screen replacement in Kolkata (Call – 9088888835)

By October 30, 2017Apple, How to's, iPhone
iPhone 7 screen replacement in Kolkata

iPhone 7 screen replacement in Kolkata yes it is possible and it will not burn your pockets like apple service station does. iPhone 7 screen replacement is a delicate process though it may look similar to iphone 6 or 6s screen replacement but there is more to it than meets the eye.

iPhone 7 screen replacement in Kolkata

 

iPhone 7 is actually a very delicate and complicated device to work with because it may look similar to iphone 6S or 6 plus but inside it is very different not just because of the software aspects but from the hardware aspects as well.

So, let us tell you how to do a iphone 7 screen replacement in kolkata.

 

iPhone 7 screen replacement technique

 

Remove the Pentalobe screws at the bottom – 

Before you try anything make sure the iphone 7 battery power level is below 10% because battery of any phone is hazardous and if it has power it could explode due to tampering with it.

Turn off your phone before you start.

Now remove the screws at the bottom edge of the iPhone 7 –

 

iphone 7 screen replacement in Kolkata

 

Opening the screen will damage the adhesive waterproof seal of the iphone so if you do not replace the seals, your phone will no longer be water resistant.

 

How to take off the screen?

You can heat up the screen edges by using a blower or dryer or you can use a opener to loosen the screen from the main iphone 7 body. Now attach a suction cup to the left lower side of the screen, just keep in mind it is not on top of the home button.

 

Iphone 7 screen repair in kolkata

 

Now use a spudger and pull the suction cup slowly this will create a small gap between the screen and the body using the spudger.

 

iphone 7 screen repair in kolkata

 

Now slide an opening pick in between the gap to open it completely. Be careful not to damage the plastic clips on the top edge of the phone. Now pull the display very slowly

 

Battery Removal:

Remove the tri point screws from the lower casket first.

 

iphone 7 screen replacement in kolkata

 

Now remove the casket using tweezers

 

apple iphone 7 screen repair in kolkata

 

After removing the casket remove the battery connector using the spudger’s pointy end –

 

iphone screen replacement in kolkata

 

 

Display Assembly

Then disconnect the lower display connectors using the spudger

 

iphone 7 screen connector

 

Remove the top two screws securing the bracket over the front panel sensor assembly connector.

Remove the two 1.3 mm Phillips screws securing the bracket over the front panel sensor assembly connector.

 

Disconnect the front panel assembly connector from its socket on the logic board

Iphone 7 assembly panel

 

Remove the display assembly –

iphone 7 display assembly

 

Remove the four screws securing the bracket over the home/Touch ID sensor

 

Remove the four Y000 screws securing the bracket over the home/Touch ID sensor:

Remove the bracket which secures the home/Touch ID sensor while iphone 7 screen replacement in kolkata.

 

Remove the bracket that secures the home/Touch ID sensor.

Pry under the left edge of the home button cable connector to disconnect it from its socket.

 

If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.

If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.

iphone 7 touch id replacement

Carefully pry up the underlying connector and move it out of the way of the home/Touch ID cable. If the connector doesn’t pry up easily, use a hair dryer or blower to heat and soften the adhesive securing the connector, and then try again.

Use an opening pick to gently separate the adhesive holding the home/Touch ID sensor cable to the back side of the display panel while iphone 7 screen replacement in kolkata

Use an opening pick to gently separate the adhesive holding the home/Touch ID sensor cable to the back side of the display panel.

Remove the home/Touch ID sensor assembly while iphone 7 screen replacement in kolkata

Remove the home/Touch ID sensor assembly.

 

Now remove the camera module from the top

iphone 7 camera module replacement

iphone 7 camera module replacement in kolkata

iphone 7 camera module replacement in kolkata

 

This is how you can change the iphone 7 screen just reverse this process and you will be able to change the screen on your own.

iPhone 7 is a delicate device so please whatever you do if you try this by yourself always remember to do it in-front of a professional supervision.

And for iphone 7 screen replacement in kolkata you can always contact us just ping us on the live chat. 

 

iPhone 7 screen replacement in Kolkata

 

Pritam Das

Author Pritam Das

Pritam Das is a Digital Marketer and content writer and editor for techyuga. A corporate cannon by day and a musician by night. A socially introvert person whom you can find on twitter @falconite91.

More posts by Pritam Das

Join the discussion 2 Comments

Leave a Reply